Intel DB65AL Andrews Lake stepping B3

Scalable solid motherboard for home use purpose.It's up to you whether you decide to use an integrated graphics chip located in the supported Intel Sandy Bridge, or if you buy a separate graphics card, which sit in the second PCI Express slot0 x16 bandwidth.Using an integrated graphics chip will allow Intel B65 chipset, which also supports SATA III and 8 lines PCI Express 2nd0 with full width of the 5 GT/s.The chipset is based on the B3 revision at which has already been fixed for SATA controllers.

For memory on board prepared a total of 4 DIMM slots.The maximum permitted capacity of 32 gigabytesThe support of two-channel connection.When installing hard drives and optical drives you will have a choice of 5 SATA 1 SATA II and III connector.Connecting peripherals procure the rear panel contains a set of 6 USB 20 ports.There Gigabit network card and audio codec allowing dual stream in the distribution of the fifth1 + 2.0 on the front panel.Connecting to a monitor, TV or projector procure classic analog D-sub connector and digital DVI-D.For larger work surface is possible to use both connectors for simultaneous connection of two display panels.

Specifications:

Supported processors:
Series:Intel Sandy Bridge
Base:LGA 1155
Max.TDP:95 W

Chipset:
Intel B65

Memory:
Type:DDR3
Slot:4x DIMM
Frequency:1333 MHz
Connection mode:Dual-channel
Max.capacity:32 gigabytes

Video:
According processor fitted

Audio:
Intel HD Audio
6 + 2 channels

LAN:
10/100/1000 Mbit/s

Expansion Slots:
1x PCI Express 2nd0 x16
1x PCI Express 2nd0 x4
1x PCI Express 2nd0 x1
1x PCI

Internal interface:
1x SATA III (6 Gbit/s)
5x SATA (3 Gbit/s)
3x USB 20 connector (6 additional USB 2Port 0)
1 x COM connector
1 x S/PDIF output connector

External interfaces:
1x DVI-D
1x VGA (D-sub)
6x USB 20
1x RJ-45
3x Audio jack
1x PS/2

Design:
Micro-ATX