FSP Fortron Hydro Ti PRO 1000W
FSP Fortron Hydro Ti PRO 1000W
The FSP Fortron Hydro Ti PRO 1000W computer power supply powers PC builds that demand stability and high efficiency. With a total output of 1000W and full ATX 3.1 certification, it delivers consistent energy even for the most demanding processors and graphics cards. Its compact 150mm length makes installation easy, while the fully modular cable system promotes a clean build and airflow inside the case. This power supply combines high performance with quiet operation, confirmed by its Cybenetics certification.
1000W
Power
ATX
Form factor
80 PLUS Titanium
Certification
Fully
Modularity
Key technologies of the FSP Fortron Hydro Ti PRO 1000W computer power supply
- Total power output of 1000W
- 80 PLUS Titanium efficiency certification
- Noise level meets the Cybenetics Lambda A++ standard
- Fully modular cable design
- Cooling provided by a fluid dynamic bearing fan
- PCB with a protective coating against moisture and dust
- Equipped with high-temperature resistant Japanese capacitors
- Includes a 12VHPWR connector that supports PCIe 5.0 graphics cards
Choosing a power supply
When choosing a suitable PC power supply, the key parameter besides the form factor is its power output. This indicates the maximum number of watts the power supply can continuously deliver to the computer's components. It is advisable to use a web-based calculator to determine the optimal power output based on your chosen components.
80 PLUS Titanium and safe operation
The power supply is 80 PLUS Titanium certified, confirming its very high energy efficiency. At a typical 50% load, it achieves over 94% efficiency, minimising energy loss and reducing waste heat generation. Lower heat output also reduces the cooling demands of the entire build and contributes to quieter operation. Safety for connected components is ensured by a complete set of electrical protections – against overcurrent, overvoltage, overload, short circuits, and overheating. These protective mechanisms safeguard your hardware during unusual power grid situations or in the event of a component failure.
Stable voltage and efficient cooling
The independent Cybenetics Lambda A++ certification attests to an operational noise level below 15 dB(A). Cooling is handled by a 135mm fan with fluid dynamic bearings (FDB), which reduce friction and extend its lifespan. The power supply uses a Zero RPM mode, which completely turns off the fan at loads below 50% to ensure silent operation during everyday tasks. The internal components consist exclusively of Japanese electrolytic capacitors rated for an operating temperature of up to 105°C, contributing to high voltage stability and long-term reliability even under continuous high loads.
ATX 3.1 and PCIe 5.0 for modern builds
Despite its high power output, the power supply maintains a standard ATX form factor with a length of 150mm. The smaller dimensions simplify cable management and improve airflow, which contributes to better cooling for other components in the build. Full compatibility with ATX 3.1 and PCIe 5.0 standards prepares the system for modern hardware. The power supply includes a native 12VHPWR connector for graphics cards, capable of delivering up to 600W through a single cable. The design handles the short-term power spikes typical of modern graphics accelerators and maintains system stability.
Protective coating for the PCB
The internal electronics are treated with a special protective coating that shields sensitive components from dust and moisture, up to 95% relative humidity. This protection increases the overall reliability and durability of the power supply, especially in more demanding operating conditions or environments with higher dust levels, and extends its lifespan.
Connectors
- 12× SATA 15-pin
- 5× PCI-E 6+2-pin
- 4× Molex 4-pin
- 2× CPU 4+4-pin
- 1× PCI-E 16-pin
- 1× ATX 24-pin
Package contents
- Computer power supply
- Power cable
- Set of mounting screws
- Interchangeable side stickers
- 1× ATX 24-pin
- 1× PCI-E 6+2-pin
- 1× Double PCI-E 6+2-pin
- 1× CPU 4+4-pin
- 1× SATA/MOLEX
- 2× SATA
- 1× PCI-E 12VHPWR
80 Plus certification in the European market
The 80 Plus certification was created to objectively evaluate the efficiency of computer power supply units. This gives users a simple and clear way to compare different models. On the European market (where 230V is the standard voltage), there are six levels of 80 Plus certification, each with specific requirements for computer power supplies. Higher energy efficiency primarily means lower energy consumption.
| PC power supply load | Efficiency at 20% load | Efficiency at 50% load | Efficiency at 100% load |
|---|---|---|---|
| 80 PLUS | 82% | 85% | 82% |
| 80 PLUS Bronze | 85% | 88% | 85% |
| 80 PLUS Silver | 87% | 90% | 87% |
| 80 PLUS Gold | 90% | 92% | 89% |
| 80 PLUS Platinum | 92% | 94% | 90% |
| 80 PLUS Titanium | 94% | 96% | 94% |
Specifications
Performance and format
Equipment
Efficiency
Connectors
Cooling system
Dimensions
Carl-Friedrich-Benz-Straße 13, 47877 Willich, GERMANY, https://www.fsp-group.com/en/index.html, +49 2154 894 012, [email protected]
Specifications can be changed without notice. Images are for illustrative purposes only.
