POE-PAN16-GB

The POE-PAN16 GB panel can feed passive power to 16 PoE injector devices with an integrated PoE extractor. It is a cost-effective solution for remote PoE powering of wireless devices, IP phones, IP cameras, and so on. Without this injector you would have to buy new expensive PoE switches or multiple individual injectors. If the powered device does not have a POE extractor, it can be combined with a passive POE splitter. This version boasts support for up to 1Gbps bitrate over Gigabit Ethernet and mainly through a 19" rack.

Key features of the POE-PAN16-GB

• Bulk, economical PoE power supply
• It can handle 16 PoE devices from a 19" rack
• Supports Gigabit Ethernet and passive PoE
• Current protection up to 650mA (+/- 15%) at each port
• Three-stage LED signaling of current values ??on three groups of ports
• Compatible with power supply pins 1/2- and 3/6 + (CISCO ...) and 4/5 + and 7/8- (MIKROTIK, UBIQUITI ...)
• Power supply not included (buy according to planned subscription)

Gigabit passive PoE injector PoE-PAN16-GB with an easy installation

The device is not complicated to set up. The main part of the installation consists of connecting the cables. Just plug in the Ethernet ports from the existing network from one side of the POE-PAN16-GB and on the other hand connect the cables to the PoE devices that use the data line simultaneously for power. Two 2.1mm jacks are used to power the POE-PAN16-GB.

Parameters and Specifications:

Interface:
16× RJ-45 shielded input (data)
16× RJ-45 shielded output (data + power supply)

Input:
2x 24 - 57 V DC 2,1 mm connector (120W)

Ethernet:
TIA/EIA 568 Cat. 5

Dimensions:
482.6 × 44.3 × 52mm

Weight:
1.4kg